1.
At the end of the shift or work day, close the cylinder valve AND bleed the pressure off the regulator AND torch equipment.
在下班或工作日结束的时候，关闭钢瓶阀门，放出调整器和吹管设备内的压力。
2.
Never reverse flow through a regulator or rely upon it to act AS a check valve. It will not perform this function.
禁止通过调整器倒流或依靠它作为止回阀。它不允许执行这个功能。
3.
Like the single-stage regulator, outlet pressure from the first stage of the two-stage regulator rises AS cylinder pressure decreASes.
同单级调整器一样，两级调整器的第一级的出口压力随钢瓶压力的降低而升高。
4.
All right, Wedge.Go FOR the power regulator on the north tower
好了，伟格把所有火力对准主机
5.
Replace your regulators before they are worn out. The operation of a compressed gas regulator to the point of failure IS a false economy.
在调整器老化之前替换它。把压缩气体调整器一直用到它失效是伪节约。
6.
Attach the regulator. Fasten the regulator to the cylinder and tighten the inlet NUT securely.
连接调整器。把调整器紧固在钢瓶上，安全地上紧入口螺母。
7.
Use a pressure-reducing regulatOR OR separate control valve to safely discharge gas from a cylinder.
使用减压调整器或单独的控制阀门来从钢瓶内安全的排出气体。
8.
always pressurize a regulator slowly, while standing with the cylinder valve between you and the regulator.
总是站得使钢瓶阀门位于你和调整器之间，对调整器慢慢加压。
9.
Plug the flow regulator into the wall and attach the nebulizer
将气流调节器插头接通墙上电源，并连接喷雾器。
10.
Inspect the regulator. Check the regulator for evidence of damage or contamination.
检查调整器。检查调整器是否有损伤或污染的迹象。
小测验：选择正确的单词
词汇听力：
